TRADI HC™ FRESCOAT

Authentic recipe which has been used for centuries to cure and protect the building.
With TRADI HC™ FRESCOAT, you can achieve natural and vibrant finishes similar to Art Decorative solutions which you can see in the dedicated decorative magazine for interiors.

Read more
020020023023026026029029057057072072075075078078086086092092Other colour (contact us)Other colour (contact us)
10 KG10 KG
BagBag
Clear

Description

  • VOC free
  • Authentic colours
  • Breathable
  • Traditional sanitization of the wall

Shelf life and Guarantee
12 months from production date if kept sealed in original container and stored in dry conditions. Manufacturer Civil Responsibility.

Working Temperature
Not below 8° C or above 30° C. Protect painted areas from direct sunlight, drying wind and rain for 3 to 4 days (longer in dam weather conditions). Do not use warm air dryers.

Suitable Background
Can be applied to gypsum plaster, cement and/or lime backgrounds, bricks, blocks and untreated timber. In order to avoid shadowing from differential background, support uniformization shall be done using TRADI HC™ PLASTER BASE (https://www.stastierlimemortars.co.uk/lime/tradi-hc-plasterbase/).
Make a compatibility test in a small area before applying totally (specially for timber background).

Mixing
The general ratio is 1 volume of powder to 2 volume of clean water. Further dilution might be necessary on porous backgrounds. Proper mixing is essential. When mixed it should be completely free of lumps or fine particles.

Application
On straight surface, apply with a brush the mix and immediately after, polish with a ‘japanese’ trowel until you achieve the desired finish.

Background
Remove any loose or flaking paints and repair defective plasters or renders. Test the background for suction by lightly flicking clean water from a brush on to the surface of the wall. Rapid suction into the background means that dampening with clean water will be required. In this case it may also be necessary to thin the first coat with 30% additional water. If thinning is required mix as normal then take out with a measured container the quantity you require to be thinned, place it in a separate container and add the extra water. A low suction background does not require pre wetting or additional thinning for the first coat. Very smooth or polished surfaces offering little or no suction might require sanding down with sandpaper to create the necessary suction. Ensure that background is dry, clean and sound. Do not use in areas subjected to abnormal condensation such as a kitchen or bathrooms, unless sufficient ventilation is available to prevent condensation. Lime paints are not film-forming materials that will hide the background condition therefore salts and dampness will show through. Some surfaces may have variations in background materials (i.e.: brick, stone, cement, etc) and therefore care is required in controlling differing suction levels. Extremely smooth gypsum plaster offering no suction need to be lightly sanded down to provide a suitable surface before applying TRADI HC™ FRESCOAT.

Recommendation: Before starting, always try on a small test area.
Health and Safety: : Follow the instructions on the safety data sheet and wear appropriate equipment (gloves, mask, safety shoes…)
This document is for general information only and does not constitute a specification. For further guidance, contact your Saint-Astier® agent.

Get more product information

Additional information

Colour

020, 023, 026, 029, 057, 072, 075, 078, 086, 092, Other colour (contact us)

Bag weight

10 KG

Packaging

Bag

Download